Meiji Techno TC5000 Series Manual de instrucciones descargar pdf (Pagina 13)

2.3 Microscope Set Up

• As a first step, remove all components from the shipping

container and remove the packing materials. Save the

container and packing in a dry location.

• Place the microscope frame on a stable work surface.

• DO NOT PLUG IN THE MICROSCOPE AT THIS POINT.

• Loosen the clamp screw on the microscope limb with the

supplied 2mm allen wrench and then install the binocular

head (MA814) or the optional trinocular head (MA816)

and re-tighten the clamp screw while the head is in the

correct position as shown in Figure 1.

• Install the two eyepieces (MA817) by sliding them into

the head and then install the rubber eyeshields on top of

each eyepiece. The eyepieces for TC-5000 Series are a

standard 30mm diameter.

• Attach the condenser by screwing the condenser into the

condenser holder of the transmitted-light illumination

carrier from underneath as shown in Figure 2.

• Connect the cable from the transmitted-light illumination

carrier to the power supply via the power socket on the

rear of the instrument as shown in Figure 3.

• Remove the objectives

from their objective cases

while being careful not to

touch any part of the optics.

Then, screw each objective

into a nosepiece opening

after removing each

nosepiece dust plug. Install them incrementally or in

order of power (e.g. 4, 10, 20, and 40) as shown in Figure

• Next, install the stage glass insert into the center of the

stage as shown in Figure 5.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 41 42

Sin comentarios

Meiji Techno TC5000 Series Manual de instrucciones Pagina 13