Meiji Techno TC5000 Series Manual de instrucciones descargar pdf (Pagina 14)

• If purchased, un-wrap the mechanical stage

(MA380/05). Locate the two holes on the bottom side

of the plain stage on the right hand side. The two

thumbscrews will attach the mechanical stage to the

plain stage as shown in Figure 6. Tighten the

thumbscrews snugly. Verify the smooth operation of

the mechanical stage by turning the coaxial controls

and checking for full un-restricted travel and

movement.

• Plug the power cord into the microscope as shown in

Figure 7 and the other end into a grounded outlet. Your

TC has a voltage sensing power supply so it can use

voltage from any country in the world from 100 volts to

240 volts AC.

The mains power cord should only be plugged into a known grounded outlet.

Contact your facilities technician if you are unsure of your mains outlet status. A simple

outlet tester can be used to verify correct outlet polarity and the presence of a grounded

circuit.

If no other accessories are going to be installed, the instrument is now ready for use.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Sin comentarios

Meiji Techno TC5000 Series Manual de instrucciones Pagina 14