Meiji Techno TC5000 Series Manual de instrucciones descargar pdf (Pagina 15)

2.4 Installing the Phase Contrast Slider

These instructions are only to be followed if you currently have a Model

TC-5100, TC-5200, TC-5500 and TC-5600 and you wish to upgrade your

microscope to perform Phase Contrast Microscopy.

In addition to installing Phase Contrast objectives, the Phase Contrast Slider will also

have to be installed. Fortunately, the procedure is very simple.

Upgrading Your Microscope with Phase

Contrast

• First, remove the brightfield objectives from your

microscope and return them to their storage

containers that came with the microscope.

• Next, install your new Phase Contrast objectives

into the nosepiece in the order of magnitude, i.e.:

4X, 10X, 20X and 40X.

• Next, locate the slot where the Phase Contrast slider

will be installed. The Phase Contrast slider will

install just below the Aperture Diaphragm on the

integrated illuminator. The slot is covered by a

plate that will need to be removed by loosening the

Phillips screw holding the plate into place as shown

in Figure 1.

• Once the screw is removed, the plate can be easily

pushed through to the back and removed entirely as

shown in Figure 2. Re-install the screw into the

plate for safe keeping.

• Next, remove the Phase Contrast slider knob on the

end and insert the slider into the newly opened slot

with the text markings facing upwards as shown in

Figure 3.

• Lastly, re-install the chrome knob back onto the

slider as shown in Figure 4. The knob prevents the

slider from being removed.

Your microscope is now equipped for Phase Contrast

observations. Refer to section 3.2 for instructions regarding

Phase Contrast microscopy.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Sin comentarios

Meiji Techno TC5000 Series Manual de instrucciones Pagina 15